AGS Merlin 1000S 설치 및 운영 매뉴얼 - 페이지 10

{카테고리_이름} AGS Merlin 1000S에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Merlin 1000S 16 페이지. Gas utility isolation controller
AGS Merlin 1000S에 대해서도 마찬가지입니다: 사용자 및 설치 매뉴얼 (10 페이지), 설치, 운영 및 유지보수 매뉴얼 (10 페이지), 설치 및 운영 매뉴얼 (12 페이지)

페이지 인쇄
AGS Merlin 1000S 설치 및 운영 매뉴얼
Installation & Operation Manual

OPERATION

First Power Up

On connecting mains power, an LED on the front of the panel (AGS Logo) will illuminate red.
Turn the key switch to on position.
Turn the key switch to the off position to turn the panel off.

Emergency Shut Off Button

The emergency shut off button is located on the front of the panel.
There is also a facility for remote shut off buttons to be wired in series on the circuit board.
The emergency shut off button(s) will cut off the gas supply and electrics only when activated.
To reinstate the system, the emergency shut off button(s) will need to be reset and the panel
restarted.

LED Indicators

Gas On
When the key switch is turned on, the Merlin 1000S will check the installation for gas leaks. If gas
proving is successful, the gas valve will open and the 'Gas On' LED will illuminate.
ON = Gas On
OFF = Gas Off
Testing
This LED will illuminate GREEN for approximately 30 seconds when the panel is checking the
integrity of the gas installation upon start up.
ON = proving the gas line, do NOT operate any appliances.
1000S IOM Rev: 07
01-20
Merlin 1000S
10