Galvin Engineering CliniMix CP-BS WM-TMVPMB 제품 설치 매뉴얼 - 페이지 13

{카테고리_이름} Galvin Engineering CliniMix CP-BS WM-TMVPMB에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering CliniMix CP-BS WM-TMVPMB 18 페이지. Hob mounted thermostatic progressive basin mixer - lever

Galvin Engineering CliniMix CP-BS WM-TMVPMB 제품 설치 매뉴얼
11.0

DISINFECTION

Swapping the hoses allows an engineer to feed water from the hot water source into the cold inlet. This hot water then passes
through the cold inlet, the thermostatic mixing chamber and out through the mixed water outlet.
Safety Note: Care should be taken when carrying out the following procedure to avoid contact with hot water and hot
surfaces. We recommend the use of protective hand wear.
1. Isolate water supply
 Turn both handles clockwise until they're fully off.
3. Swap Hoses
 Swap the hoses. Attach the cold hose on the hot outlet and the hot hose on the cold outlet.
Turn the hot inlet tap anti-clockwise to enable hot water flow.
2. Remove hoses
 Using a spanner, turn both hose nuts anti-clockwise
and remove.
13
Version 2, 29 May 2020, 13 of 18