Galvin Engineering Ezy-Drink Lead Safe SS316 설치 매뉴얼 - 페이지 2

{카테고리_이름} Galvin Engineering Ezy-Drink Lead Safe SS316에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering Ezy-Drink Lead Safe SS316 4 페이지. Remote push button drinking bubbler

페이지 인쇄

Product Installation Guidelines

PRE-INSTALLATION -

−

If the mounting holes do not already exist, mark out and drill the holes in the bench/trough, as shown in

rough-in dimensions.

Note: Supplied flexi hose length is 225mm long. Maximum distance between outlet and handle is 180mm.

Note: Before installation, all lines must be flushed.

We recommend that a line strainer be installed prior to drinking taps to eliminate any foreign material

Rough-In Dimensions

*Only drill Ø2.5mm hole if anti-

rotation pin (not supplied) is

INSTALLATION

IMPORTANT: Galvin Engineering products must be installed in accordance with these installation instructions

and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical

supply conditions must also comply to the applicable national and/or state standards. Failing to comply with

these provisions shall void the product warranty and may affect the performance of the product.

1. Disassembly

− Remove the push button handle using the

provided 2mm hex key to loosen the grub

screw.

− Remove the stainless steel lock nut using

an appropriate sized wrench. Do not

remove the top assembly.

−

Remove back nut and cup washer from the

outlet assembly.

MOUNTING DETAILS

required.

2. Fit body & mouthguard outlet

−

Fit the valve body and mouthguard outlet into the

trough ensuring the rubber washers are placed

between.

−

Secure outlet underneath with the supplied cup

washer and back nut.

−

Secure valve body using the stainless steel locknut.

−

Take care not to over-tighten.

Version 4, 25

October 2022, Page 2 of 5