Galvin Engineering Ezy-Wash TF81HJP 제품 설치 매뉴얼 - 페이지 2

{카테고리_이름} Galvin Engineering Ezy-Wash TF81HJP에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering Ezy-Wash TF81HJP 5 페이지. Pre-rinse tapware

Version 1, 3 August 2017, Page 2 of 5

PRE-INSTALLATION

Body:



If the mounting hole does not already exist,

mark out and drill the hole in the bench, as

shown.



This model is a single inlet unit requiring a hole

diameter of 23 to 26mm. Ensure 70mm

minimum between wall and hole center as

shown "A".



Maximum bench thickness is 50mm.

Wall Bracket:



Mark out the three (3) holes for mounting the

wall bracket assembly at a height of between

430mm min - 520mm max directly up from the

bench. Cut out or drill as shown in the image.

(Supplied fasteners may not be suitable for the

mounting surface. If this is the case, suitable

fasteners will need to be sourced by the

installer)

Note: We recommend the wall bracket is installed

at the maximum of 520mm. The wall bracket can be

mounted lower at a height of up to 90mm below the

circlip. However, the further it is mounted away

from the circlip, the more the stability of the unit is

compromised.

TF81HJS – Assembly

Version 2, 3 August 2017, Page 2 of 5

TF81HJP - Assembly