Galvin Engineering TCWBJ150C 제품 설치 - 페이지 5

{카테고리_이름} Galvin Engineering TCWBJ150C에 대한 제품 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering TCWBJ150C 5 페이지. Cp-bs hospital wall bath set taps w/ 180 outlet lamina

페이지 인쇄

Product Installation Guidelines

SERVICE AND MAINTENANCE

JUMPER VALVE TAPWARE

1. Turn off the water supply and turn on the tap

handle to drain water from the bodies.

2. Remove the temperature indicator from the

handle.

3. Remove the handle from the tap.

4. Unscrew the top assembly from the body.

5. Check the o-ring on the spindle and the

jumper valve for wear and damage.

Replace if required.

6. Clean the spindle and body of debris.

7. Place a new o-ring (if required) onto the

spindle and re-grease with potable water

approved grease.

8. Re-assemble top assembly. Follow the product

installation guidelines for the relevant product

to re-assembly method.

WARRANTY

The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering

Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or

implied. Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied,

including but not limited to the implied warranties of merchantability and fitness for a particular purpose.

Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download

from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free

from operational defects in workmanship and materials for the warranty period as shown on the schedule

in the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any

defective products manufactured by Galvin Engineering without charge, so long as the terms of the

Manufacturer's warranty are complied with.

The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy

for breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special

or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other

property which is damaged if this product does not work properly, other costs resulting from labour charges,

delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,

chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty

shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance

or alteration of the product.

Version 2, 7 April 2022, Page 5 of 5

CERAMIC DISC TAPWARE

1. Turn off the water supply and turn on the tap

handle to drain water from the bodies.

2. Remove the temperature indicator from the

handle.

3. Remove the handle from the tap.

4. Unscrew the ceramic head part from the

body.

5. Check the o-ring on the ceramic head part

for wear and damage. Replace if required.

6. Clean the head part and the body of any

debris.

7. Replace the cartridge and hand tighten back

into the body.

8. Follow the product installation guidelines for

the relevant product to re-assemble.

Document No.: 001.00.10.05

Version 1, 7 April 2022, Page 5 of 5