AGS Parksafe Control Panel 설치 및 운영 매뉴얼 - 페이지 6

{카테고리_이름} AGS Parksafe Control Panel에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Parksafe Control Panel 16 페이지. Ventilation control panel
AGS Parksafe Control Panel에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (16 페이지), 설치 운영 및 유지보수 (16 페이지), 설치, 운영 및 유지보수 매뉴얼 (20 페이지)

페이지 인쇄

Installation & Operation Manual

Parksafe Detector Identification

When wiring multiple detectors to the Parksafe panel it is important to identify each detector

and in which monitoring zone the detector is located for the Park Safe system to receive and

display data. Detector ID switches are fitted to detector circuit boards.

For more information refer to your Parksafe detector manual.

Detector Chain Termination Resistor Switch

Signal communication issues may occur where the bus length is too long or

high baud rates are used. In this instance – terminating at each end of the

chain may help the quality of the data signal. To do this - turn on the

[CHAIN TERMINATION RESISTOR] switch.

For more information refer to your Parksafe detector manual.

Settings Switch

On the front display circuit board you'll find a SETTINGS

switch – when switched to ON, the screen will display

the settings menu – you can now configure your

Parksafe system.

When changes have been made – turn the SETTINGS

switch off and the system will automatically restart.

Settings Menu

The Parksafe panel has a touch screen which allows the engineer/ user to configure the system.

Adjust the screen brightness.

(Press or slide the cursor up and down)

AGS Parksafe - IOM Iss: DRAFT 3 06-20

Change/select option.

(Press the blue option box or press and hold)

Parksafe Control Panel