AGS Parksafe Control Panel Посібник з монтажу та експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Контролер AGS Parksafe Control Panel. AGS Parksafe Control Panel 16 сторінок. Ventilation control panel
Також для AGS Parksafe Control Panel: Посібник з монтажу та експлуатації (16 сторінок), Експлуатація та технічне обслуговування установки (16 сторінок), Посібник з монтажу, експлуатації та технічного обслуговування (20 сторінок)

Installation & Operation Manual

Parksafe Detector Identification

When wiring multiple detectors to the Parksafe panel it is important to identify each detector

and in which monitoring zone the detector is located for the Park Safe system to receive and

display data. Detector ID switches are fitted to detector circuit boards.

For more information refer to your Parksafe detector manual.

Signal communication issues may occur where the bus length is too long or

high baud rates are used. In this instance – terminating at each end of the

chain may help the quality of the data signal. To do this - turn on the

[CHAIN TERMINATION RESISTOR] switch.

For more information refer to your Parksafe detector manual.

On the front display circuit board you'll find a SETTINGS

switch – when switched to ON, the screen will display

the settings menu – you can now configure your

Parksafe system.

When changes have been made – turn the SETTINGS

switch off and the system will automatically restart.

The Parksafe panel has a touch screen which allows the engineer/ user to configure the system.

Adjust the screen brightness.

(Press or slide the cursor up and down)

AGS Parksafe - IOM Iss: DRAFT 3 06-20

Change/select option.

(Press the blue option box or press and hold)

Parksafe Control Panel