Galvin Engineering CliniLever TC51FC1C 설치 매뉴얼 - 페이지 3

{카테고리_이름} Galvin Engineering CliniLever TC51FC1C에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering CliniLever TC51FC1C 4 페이지. Cp-bs hospital wall mixing set type 51 fixed 150 c/d

페이지 인쇄

Product Installation Guidelines

3. CliniLever

body

−

Check maintenance tails to ensure o-rings are

fitted correctly and are in good condition.

−

Fit the CliniLever

tails until it sits flush against them, taking care

not to damage the o-rings.

TROUBLESHOOTING

PROBLEM

Taps are dripping water

Water is not flowing from tap

Handle is loose

Flange does not screw down

onto basin/sink surface

body onto the maintenance

CAUSE

Ceramic discs are worn or damaged

Tap seat is damaged

Water is turned off

Aerator or flow regulator is blocked

by debris

Screw has come loose

Tap bodies are set too far out

4. Fit grub screws and testing

−

Ensure the CliniLever

against the maintenance tail and then secure

in place with the supplied grub screws.

ENSURE ALL FOUR (4) GRUB SCREWS

ARE FITTED WITH SUPPLIED ALLEN KEY.

If grub screws are missing, contact us on

1300 514 074.

−

Once grub screws are secure, open the

regulating valve prior to the tap. Open the

lever handles and ensure there is flow from

both hot and cold inlets. Inspect the tap and

check for any leaks.

RECTIFICATION

Remove and inspect SBA.

Remove debris and/or replace

SBA if damaged.

Refurbish tap seat using a

reseating tool.

Turn water on

Remove aerator and/or flow

regulator from tap and remove

debris. Install an inline strainer.

Tighten handle screw

Re-position tap bodies and breach

piece

Version 3, 27 August 2021, Page 3 of 4

body is pushed firmly