Galvin Engineering TCS9C150C 설치 매뉴얼 - 페이지 4

{카테고리_이름} Galvin Engineering TCS9C150C에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering TCS9C150C 7 페이지. Clinilever cp-bs hospital shower set w/ medi hand shower & 900 ss grab rail

페이지 인쇄

Product Installation Guidelines

INSTALLATION - SHOWER

INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these

installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.

Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.

Failing to comply with these provisions shall void the product warranty and may affect the performance of the

product.

WARNING: Install with stainless steel

304 or 316 screws. Other type of

screws may rust and void warranty.

1. Install straight grab rails including the

horizontal section of any grab rail (if

applicable) as per AS 1428.1, 800-810mm

from floor to top of rail. Make sure the wall

surface is flat and free from contaminants.

Remove flange protector from grab rail

flange. Align guide lug marks from step 2 and

mark wall through base holes to pinpoint

screw holes.

When marking out the grab

rails, use centre base holes of

flange protector.

2. For straight grab rails, position the flange

Version 1, 4 November 2022, Page 4 of 7

When marking out corner grab rails

follow the fixing guide lug diagram

shown above to suit grab rail

orientation.

protector guide lugs either vertical or

horizontal.

Fit dress ring if applicable. Drill spot

marks with 7mm bit. Screw wall mount

plate to wall. Ensure screws engage wall

stud or other solid substrate.

Document No.: 001.00.10.16