hikam Q7 빠른 매뉴얼 - 페이지 8

{카테고리_이름} hikam Q7에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. hikam Q7 8 페이지. Smart home wireless ip-camera
hikam Q7에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지)

Video record doesn't work!



My Camera -> Setting -> Record Settings, to choose how to record and switch it on



Make sure the SD Card is inserted correctly and the corresponding LED is on.



Make sure the SD Card is not kaput. If necessary, check the SD Card on your PC

Forget the device password!



There is a reset hole at the bottom of the camera, use a toothpick or similar objects

inserted into the reset hole, restore the initial password: 123.

Forget the App password!



WiFi Configuration / QR Code don't work!



Check the Wi-Fi Antenna is mounted correctly.



Select the correct WiFi from the network list and re-enter the WiFi password



The camera needs several seconds to read the QR Code, hold your smart phone

steadily. Keep the distance from the camera to your smart phone between 20cm to

30cm.



If the camera is already configured with one network, it will not accept another

configuration. If you DO want to change the configuration, reset the device with the

reset hole. See "Forget the device password" above.



Connect the camera to the router with Ethernet cable and check whether the camera is

working. You can also configure the WiFi settings in this way.



Configure the WiFi at the place where you are sure the WiFi signal is strong and move

the camera to the place you want to install it.

No connection after power cycling of router!



Depending on your router and ISP (Internet Service Provider), the camera needs

several seconds or minutes to re-connect to the internet. Wait a while and try again.

No connection although Ethernet or WiFi!



Check the router is connected to the internet.