Galvin Specialised SHWR-DV-01 제품 설치 매뉴얼 - 페이지 2

{카테고리_이름} Galvin Specialised SHWR-DV-01에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised SHWR-DV-01 7 페이지.

Product Installation Guideline

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in accordance with

AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable

National and/or State standards. Failing to comply with these provisions shall void the product warranty and may affect the performance of

the product.

1. Fit Body assembly



Secure body with mounting bracket as

shown, so it is protruding past the

finished wall between 8 and 11mm.



Body bracket can be secured with

suitable fixings through the two slots.



It is critical that the centre line of the fitted

body is perpendicular to the finished wall

to ensure correct fitment of the faceplate

and flange.

4. Fit the control knob



Fit the control knob, ensure when the knob

is set to 'fixed shower' the handle is facing

down as shown and when rotated the

handle matches the lines on the face

plate.



Secure the handle with supplied tamper

proof screw.

TROUBLESHOOTING

PROBLEM

Face plate does not sit flush on

wall

Water flow does not match

faceplate markings

2. Connect water supply



Connect water supply to correct inlet as

shown, use a suitable thread sealing

compound making sure there are no

obstructions or blockages to the pipework.

Note: Water supply should be flushed

before fitting. The use of in-line strainers is

highly recommended.

5. Fit grub screw to flange



Fit grub screw in to flange in either hole

provided. Choosing the hole that isn't

blocked by the bracket. Tighten grub

screw to 1.5nm.

CAUSE

Diverter not mounted perpendicular to wall

Handle not aligned correctly to faceplate

Outlet on body not connected to the correct service outlet

Version 17 February 2017 Page 2 of 3

3. Fit face plate & flange



Fit O ring to flange groove.



Slide shower face plate on to body.



Tighten flange to secure.



Adjust bracket nuts to ensure face plate is

fully tightened & thighten lock nuts.

6. Testing



Once fitted turn on water and check for

leaks and correct operation.

RECTIFICATION

Remove and re-mount so the body is

perpendicular to finshed wall

Remove tamper proof screw and roate

control knob until matching faceplate

re-tighten tamper proof screw.

Change outlet connection on body