Galvo Shed GVO 1508 조립 지침 매뉴얼 - 페이지 5

{카테고리_이름} Galvo Shed GVO 1508에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvo Shed GVO 1508 8 페이지. Sloping roof shed

STEP 4

BACK WALL

Join the two sheets

together with 2 fixings through the overlapping

ribs, making sure the ends of the sheets are flush. Cap the sheeting with

the 1515mm 'U' channels

Fix the channels through the end ribs and every second rib in between.

Make sure you put at least one fixing per sheet up through the underside

of the channel into the pan of the sheet.

GALVO TIP

Put extra fixings in for

high wind areas, particularly

on the underside.

STEP 5

ROOF

Join the two sheets

together, same as the back. Cap the sheeting with the 1515mm 'U'

channels

. Fix the channels at every second rib but not the corners at this stage.

Place the short flange of the first 'L' flashing

Make sure the ends are flush with the sheeting (diagram 1) and put

one fixing in the centre to hold the 'L' flashing. Fix the corners

through the channels and one more between the corner and

the centre fixing. Perform the same at the other end.

Use five fixings in each 'L' flashing.

DIAGRAM 1

If you choose to vary from these instructions your warranty will be impaired

on top of the rib at one end.

YOU WILL NEED

2 x 1770 x 780mm sheets

2 x 1515mm 'U' channels

YOU WILL NEED

2 x 980mm x 780mm sheets

2 x 1515mm 'U' channels for the roof

2 x 980mm 'L' flashings