Dynojet 450f 설치 지침 - 페이지 4

{카테고리_이름} Dynojet 450f에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet 450f 4 페이지. 2012-2014 kawasaki kx450f

FIG.D

Unplug

FIG.E

FIG.F

Ground

17-038

www.powercommander.com

Unplug the stock Throttle Position Sensor connectors (Fig. D).

This is a 3-pin connector pair located rear of the throttle body. It is accessed

easiest from the right hand side of the bike.

The Figure D picture was taken from the left side of the bike, looking inward

between the frame and the airbox.

Plug the PCV wiring harness in-line of the stock TPS connectors (Fig. E).

Remove the upper bolt that holds the ignition coil to the frame. Use this bolt to

secure the PCV ground wire with the small ring lug at this same location on the

frame (Fig. F).

Reinstall the fuel tank, seat, and the number plate. Make sure the fuel tank

does not pinch the PCV wiring harness when reinstalled securely.

2012-2014 Kawasaki KX450F - PCV - 4