Dynojet POWER COMMANDER 설치 지침 - 페이지 2

{카테고리_이름} Dynojet POWER COMMANDER에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet POWER COMMANDER 3 페이지. For aprilia mille 2000; aprilia mille 2001; aprilia mille 2002; aprilia mille 2003
Dynojet POWER COMMANDER에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지)

페이지 인쇄
Dynojet POWER COMMANDER 설치 지침
PCIII connectors
Stock connector
Wire tap
i902-411
www.powercommander.com
Stock connector
PCIII connectors
Loosen these bolts
Grey wire from PCIII
1
Remove the seat.
2
Lift up the front of the fuel tank.
3
Disconnect the wiring harness
from the injector on the left
hand side of the bike by sqeez-
ing the connector.
4
Connect one pair of the leads
from the PCIII in-line of the
stock harness and throttle body
(Fig.A).
5
Repeat steps 3-4 for the right
hand side (Fig.B).
6
Locate the throttle position sen-
sor on the trottle bodies. Locate
the yellow wire with the brown
tracer coming from the sensor.
Connect the supplied wire tap to
this wire.
7
Plug the grey wire from the
PCIII to the wire tap (Fig. C).
Note: It is recommended to use dialec-
tric grease on these connections.
2000-2003 Aprilia Mille - PCIII USB - 2