Coram Showers OPTIMA OFFSET QUADRANT 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Coram Showers OPTIMA OFFSET QUADRANT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coram Showers OPTIMA OFFSET QUADRANT 9 페이지.

8
Check the door frame is vertical and is centrally positioned between the wall channels.
From inside the enclosure, in the 6 positions shown, drill through the wall channels into the fixed panels.
Important: The top holes MUST be 18mm down from the top. Drill using a 3mm drill bit.
Fix using 6 x 10mm screws and screw caps.
9
a
Inside of
fixed panel
PN50490
a: Attach 2 x glass clamps to each of the horizontal rails (at edge of glass) using 10mm screws, tighten by hand only - do not
overtighten. Push fit glass clamp covers.
b: Select the short vertical seals (PN40350), fit the seals to both fixed panels.
Important: Seals must sit tight against glass clamps (top and bottom).
Important: Seal 'flippers' must be on inside of the enclosure. Note: Wetting the glass with water will help fit the seals.
From inside
b
10mm
PN50488
PN40350
18mm
ø 3
mm
10mm
Inside of
fixed panel
5