AGS Merlin 2000S 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} AGS Merlin 2000S에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Merlin 2000S 12 페이지. Gas proving and ventilation interlock system
AGS Merlin 2000S에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 설치 및 운영 매뉴얼 (12 페이지)

페이지 인쇄

Installation & Operation Manual

4. BMS OUTPUT

Connections are available on the board for Building Management Systems.

[NO Normally Open] [COM Common] [NC Normally Closed]

These are volt free connections.

This is a relay that changes state in alarm or when the gas is on/off and can be used in

conjunction with the 12V DC output and other external relays that affect other devices and

controls such as purge fans and audible alarms etc.

See section; Switch Settings - for BMS options

5. EM REMOTE

Connections for remote emergency shut-off or stop buttons is detailed on the circuit board as

[EM REMOTE]. This is linked out as a factory setting.

Remote emergency shut-off buttons should be volt free and wired to the Merlin 1500S using a

plenum security cable, white, 18/2 (18AWG 2 conductor), stranded, CMP or similar.

6. GAS DETECTOR

Connections can be made for a Merlin gas detector (LPG, NG, CO or Hydrogen).

If no detector is being used leave the factory fitted link in.

A wiring example is shown.

Refer to your gas detector manual for further information.

7. FAN SWITCHES

This terminal switches when the key is turned on and off.

This can be connected to a fan switch (supplied separately) which can provide power to fans

when the control panel is switched on.

8. CO2 MONITOR

This terminal can be used to connect a Merlin CO

a high concentration of CO

If no CO2 monitor is connected, the panel will 'beep' upon power up and the CO2 LED will

flash 3 times to indicate that this terminal has been disabled.

An external power supply is required.

Refer to your CO

monitor manual for further information.

9. 12V DC

This is a power output for external auxiliary devices when there is power at the panel and can

be used to create a relay switch with the BMS relay output.

Max output: 50mA

1500S IOM Rev: 08

01-20

monitor to shut off the system in the event of

Merlin 1500S