GAMA Electronics, Inc. RF019 사용자 설명서 - 페이지 2

{카테고리_이름} GAMA Electronics, Inc. RF019에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAMA Electronics, Inc. RF019 3 페이지.

CAUTION

Batteries. All batteries can cause damage and/or bodily injury such as burns if a conductive

material such as jewelry, keys or beaded chains touches exposed terminals. The material may

complete an electrical circuit (short circuit) and become quite hot. Exercise care in handling any

charged battery, particularly when placing it inside a pocket, purse or other container with metal

objects.

Care and Safety. To clean the remote, wipe with a soft cloth dampened with water. Don't use

cleaners or solvents on the remote, they can harm the body and leak inside, causing permanent

damage. Battery contacts may be wiped with a dry, lint-free cloth.

If the remote gets wet, remove batteries immediately. Dry battery compartment with a soft cloth

to minimize potential water damage. Leave cover off the battery compartment overnight or until

completely dry. Do not use the remote until completely dry.

Installation. Perform the steps below to set the remote's unique address and install the battery.

Selection of Remote's Unique Address. The remote control contains switches that are set to

operate with a receiver/control module with matching switch positions. This allows multiple

remotes to be operated in close proximity to each other without causing interference. Refer to

Figure 1. To configure the switches in the remote, remove the four screws and separate the

plastic enclosure top from the bottom to access the switches. Locate the selector switches

(Figure 1). Using a very small tip, flat blade screwdriver, slide each actuator position to either

above or below the centerline. The switch positions must be the same as the switch positions on

the receiver/control module. Once the switches have been set, assemble the top and bottom of

the enclosure together and install the four screws.

Battery Installation. The remote control operates from one 9-volt Alkaline battery. To install

the battery, grasp the door and slide it away from the remote. Install the battery into the

compartment, which is keyed for the correct polarity. Replace the battery door onto the

enclosure.