GAMA Electronics, Inc. RF019 Руководство пользователя - Страница 2
Просмотреть онлайн или скачать pdf Руководство пользователя для Пульт дистанционного управления GAMA Electronics, Inc. RF019. GAMA Electronics, Inc. RF019 3 страницы.
Печатать страницуCAUTION
Batteries. All batteries can cause damage and/or bodily injury such as burns if a conductive
material such as jewelry, keys or beaded chains touches exposed terminals. The material may
complete an electrical circuit (short circuit) and become quite hot. Exercise care in handling any
charged battery, particularly when placing it inside a pocket, purse or other container with metal
objects.
Care and Safety. To clean the remote, wipe with a soft cloth dampened with water. Don't use
cleaners or solvents on the remote, they can harm the body and leak inside, causing permanent
damage. Battery contacts may be wiped with a dry, lint-free cloth.
If the remote gets wet, remove batteries immediately. Dry battery compartment with a soft cloth
to minimize potential water damage. Leave cover off the battery compartment overnight or until
completely dry. Do not use the remote until completely dry.
Installation. Perform the steps below to set the remote's unique address and install the battery.
Selection of Remote's Unique Address. The remote control contains switches that are set to
operate with a receiver/control module with matching switch positions. This allows multiple
remotes to be operated in close proximity to each other without causing interference. Refer to
Figure 1. To configure the switches in the remote, remove the four screws and separate the
plastic enclosure top from the bottom to access the switches. Locate the selector switches
(Figure 1). Using a very small tip, flat blade screwdriver, slide each actuator position to either
above or below the centerline. The switch positions must be the same as the switch positions on
the receiver/control module. Once the switches have been set, assemble the top and bottom of
the enclosure together and install the four screws.
Battery Installation. The remote control operates from one 9-volt Alkaline battery. To install
the battery, grasp the door and slide it away from the remote. Install the battery into the
compartment, which is keyed for the correct polarity. Replace the battery door onto the
enclosure.