Hikobike ENDURO 2022 사용자 설명서 - 페이지 14

{카테고리_이름} Hikobike ENDURO 2022에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hikobike ENDURO 2022 17 페이지.

ERROR CODES

Error

Definition

code

Normal

Current Error or Controller Damage

Throttle Error

Motor No Phase Position

Hall Sensor Error

Brake Error

Under Voltage

Motor Stalling

Communication Error from Controller

Communication Error from Display

Dealer and Bicycle mechanic routine maintenance:

Your bicycle should be taken to your servicing dealer or a bicycle mechanic after around 200 KMS of

riding for a general check and to check the spoke tension. Then every 1000 KMS for a general service

and inspection. Failure to do this can void your warranty due to unnecessary wear and tear.

User maintenance:

1. Oil the chain frequently, by using special bicycle lubricant (dry or wet). Apply the lube oil on

the chain by turning the pedals and dripping the lube oil on the chain as it moves past, and

spin for a few turns and change into all gears. It is easiest to do this on the bike stand or

bike carrier, with the wheels suspended off the ground. After applying the lube oil it is

important to clean off excess lube oil with a cloth. This removes old dirt that the new lube

has dislodged.

2. Keep tyre pressures within the tyre recommendations; see tyres for max PSI inflation.

Normally 35-55psi gives a hard tyre pressure for efficient pedalling and battery

consumption. A weekly check will save lots of pedalling energy later!

3. Check brake disc pads for even wear patterns. If the brakes become noisy when applied,

take to a service bike shop to check to see if they need replacement.

4. Store your e-bike in a dry place and away from corrosive environments.

Trouble Shooting

Check Controller

Check Throttle

Check Motor

Check Brakes

Check Battery

Check Battery / Motor

Check Controller Connections

Check Display Connections