Corbin Russwin DC8200 Series 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} Corbin Russwin DC8200 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Corbin Russwin DC8200 Series 8 페이지. Multi-sized 1 thru 6
페이지 인쇄DC8200 Regular Arm Installation Instructions
D
Attach Arm Bracket to Frame
NON-HOLD OPEN ARM ONLY:
Pivot (away from hinge)
Standard Position
Normal mounting position.
Position with pivot point
away from hinge.
Away from
hinge
E
Position Arm on Closer
NON-HOLD OPEN ARM ONLY:
Main arm projects straight out at 90° angle to door.
Install and tighten arm screw & washer assembly.
5/16 HEX HEAD
SCREW & WASHER
ASSEMBLY
MAIN ARM
F
Preload and Adjust Arm
NON-HOLD OPEN ARM ONLY:
Open door and slide arm rod into arm loop. Close door, swing arms
so adjusting arm is 90° to frame. With 7/16 wrench INSTALL and
TIGHTEN SCREW SECURELY.
SCREW
80-9380-8000-152 Rev. 09/06
B
A
Previous Page ( 2 )
#12-14 X 1-1/2 FH SELF-DRILLING (2)
#12-14 X 1-1/2 FH SELF-DRILLING (2)
For Additional 15% Closing Force
Reposition arm mounting bracket so that
pivot point is toward hinge.
Hinge
FOR MAXIMUM
POWER
"
ARM ROD
Extended Maintenance
Lubricate Arm periodically
shaded points
two of appropriate lubricant.
ARM
90°
NOTE:
TUBE
Hold Open Arm,
use any lubricant on the
Holding Surface components.
G
Adjust Door Closer: See Page
C
D
E
F
This Page
2
HOLD OPEN ARM (A1 OPTION ONLY):
HOLD OPEN ARM:
Position so that dial
screw is on
UNDERSIDE of bracket
FOR REGULAR
POWER
HOLD OPEN ARM ONLY:
While door is closed, adjust the Threaded Arm in the Arm Bracket
until the bearing fits back onto the elbow joint on the Main Arm at 90
as shown below.
at
with a drop or
When lubricating a
DO NOT
3
G
HOLD OPEN ARM ONLY:
Main arm projects straight out at 90° angle to door.
Remove arm screw and washer from elbow joint and
disassemble arm. Thread the rod into the Arm
Bracket as shown below. Install and tighten arm
screw & washer.
ARM
MAIN ARM
BRACKET
THREADED
ROD
RE-INSTALL AND TIGHTEN SCREW SECURELY.
MAIN ARM
THREADED
ARM
SCREW
8
DIAL
SCREW
°
90°