aireRyder FN56306 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} aireRyder FN56306에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aireRyder FN56306 8 페이지.

페이지 인쇄

Receiver

DIP Switch

Fig.8

Transmitter

Fig.9

For FN56305

Antenna

Fig.10

7 .

Antenna:

DO NOT CUT

OR SPLICE

Fig.11

Canopy

Screw

Secure the canopy to hanger bracket

with screws.

Antenna

There is a code switch respectively in

the transmitter and receiver. This "DIP

Switch" is a 4 key unit (Fig.9). All keys

were set at "ON" position in the beginning.

Set the keys to a different code. Make sure

the same numbered keys are switched "ON"

for both DIP Switches (Fig.9a). Take note

that the "ON" position may have different

orientation in each.

Receiver

Hanger Bracket

For FN56305

Receiver

Blade Holder

Fig.12

Tighten blades to blade holders by

using blade screws and washers.

Move Ground Wires (a), Outlet Box wires (b), and

Motor Wires (c) away from the center of the Hanger

Bracket. Then slide Receiver through Hanger

Bracket as shown, Antenna end first, until it is

centered. Finally, cut Motor Wires (c) to length

needed for connections.

Make wire connections:

1) The Motor white wire to the white "To Motor N" wire from

Receiver with a wire nut.

2) The Motor black wire to the black "To Motor L" wire from

Receiver with a wire nut.

3) The Motor blue wire to the blue "For Light" wire from Receiver

with a wire nut.

4) The Motor orange wire to the orange "For Inner Light" wire

from receiver with a wire nut (For FN56305)

Hanger

5) The white wire from Outlet Box to the red "AC in N" wire

Bracket

from Receiver with a wire nut.

6) The red wire from Outlet Box to the red "AC in L" wire from

Receiver with a wire nut.

Hanger

7) The ground wire from Outlet Box to the green ground wire

Ball

from the Hanger Ball and the green ground wire from the

Hanger Bracket with a wire nut.

Make sure all of wire nuts are connected firmly.

*** Tuck all wire nuts and wires carefully up into the Outlet Box,

EXCEPT antenna, which should remain outside Outlet Box.

Blade Screw

Washer

Blade

PAGE: 2 / 4

Fig.8a

Code example:

1-ON 2-OFF 3-ON 4-OFF

on both DIP Switches.

070421