aireRyder FN56306 Handleiding voor installatie-instructies - Pagina 6
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} aireRyder FN56306. aireRyder FN56306 8 pagina's.
Pagina afdrukken
Receiver
DIP Switch
Fig.8
Transmitter
Fig.9
For FN56305
Antenna
a.
Fig.10
3.
4.
7 .
Antenna:
DO NOT CUT
OR SPLICE
Fig.11
Canopy
Screw
Secure the canopy to hanger bracket
with screws.
Antenna
There is a code switch respectively in
the transmitter and receiver. This "DIP
Switch" is a 4 key unit (Fig.9). All keys
were set at "ON" position in the beginning.
Set the keys to a different code. Make sure
the same numbered keys are switched "ON"
for both DIP Switches (Fig.9a). Take note
that the "ON" position may have different
orientation in each.
Receiver
b.
Hanger Bracket
c.
For FN56305
2.
5.
1.
Receiver
Blade Holder
Fig.12
Tighten blades to blade holders by
using blade screws and washers.
Move Ground Wires (a), Outlet Box wires (b), and
Motor Wires (c) away from the center of the Hanger
Bracket. Then slide Receiver through Hanger
Bracket as shown, Antenna end first, until it is
centered. Finally, cut Motor Wires (c) to length
needed for connections.
Make wire connections:
6.
1) The Motor white wire to the white "To Motor N" wire from
Receiver with a wire nut.
2) The Motor black wire to the black "To Motor L" wire from
Receiver with a wire nut.
3) The Motor blue wire to the blue "For Light" wire from Receiver
with a wire nut.
4) The Motor orange wire to the orange "For Inner Light" wire
from receiver with a wire nut (For FN56305)
Hanger
5) The white wire from Outlet Box to the red "AC in N" wire
Bracket
from Receiver with a wire nut.
6) The red wire from Outlet Box to the red "AC in L" wire from
Receiver with a wire nut.
Hanger
7) The ground wire from Outlet Box to the green ground wire
Ball
from the Hanger Ball and the green ground wire from the
Hanger Bracket with a wire nut.
Make sure all of wire nuts are connected firmly.
*** Tuck all wire nuts and wires carefully up into the Outlet Box,
EXCEPT antenna, which should remain outside Outlet Box.
Blade Screw
Washer
Blade
PAGE: 2 / 4
Fig.8a
Code example:
1-ON 2-OFF 3-ON 4-OFF
on both DIP Switches.
070421
TM