HIKOKI DH 26PX2 취급 지침 매뉴얼 - 페이지 6

{카테고리_이름} HIKOKI DH 26PX2에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI DH 26PX2 16 페이지.

페이지 인쇄

○ When turning the rotary hammer on while dust collector

(B) is detached from a concrete surface, dust collector

(B) will rotate together with the drill bit. Make sure to turn

on the switch after pressing the dust cup on the concrete

surface. (When using dust collector (B) attached to a

drill bit that has more than 190 mm of overall length,

dust collector (B) cannot touch the concrete surface

and will rotate. Therefore, please use dust collector (B)

by attaching to drill bits which have an overall length of

166 mm or less.)

○ Dump particles after every two or three holes when

drilling.

○ Please replace the drill bit after removing dust collector

(B).

6. Conﬁ rm the direction of bit rotation (Fig. 5)

The bit rotates clockwise (viewed from the rear side) by

pushing the R-side of the push button.

The L-side of the push button is pushed to turn the bit

counterclockwise.

Push button

HOW TO USE

CAUTION

To prevent accidents, make sure to turn the switch

oﬀ and disconnect the plug from the receptacle when

the drill bits and other various parts are installed or

removed. The power switch should also be turned oﬀ

during a work break and after work.

1. Switch operation

The rotation speed of the drill bit can be controlled

steplessly by varying the amount that the trigger switch

is pulled. Speed is low when the trigger switch is pulled

slightly and increases as the switch is pulled more.

Continuous operation may be attained by pulling the

trigger switch and depressing the stopper. To turn the

switch OFF, pull the trigger switch again to disengage

the stopper, and release the trigger switch to its original

position.

However, the switch trigger can only be pulled in

halfway during reverse and rotates at half the speed of

forward operation.

The switch stopper is unusable during reverse.

2. Rotation + hammering

This rotary hammer can be set to rotation and

hammering mode by pressing the push button and

turning the change lever to the

Fig. 5

mark (Fig. 6).

(1) Mount the drill bit.

(2) Pull the trigger switch after applying the drill bit tip to the

drilling position (Fig. 7).

(3) Pushing the rotary hammer forcibly is not necessary

at all. Pushing slightly so that drill dust comes out

gradually is suﬃ cient.

CAUTION

When the drill bit touches construction iron bar, the bit

will stop immediately and the rotary hammer will react

to revolve. Therefore grip the side handle and handle

tightly as shown in Fig. 7.

3. Rotation only

This rotary hammer can be set to rotation only mode by

pressing the push button and turning the change lever

to the mark (Fig. 8).

Push button

To drill wood or metal material using the drill chuck

and chuck adapter (optional accessories), proceed as

follows.

Installing drill chuck and chuck adapter (Fig. 9).

(1) Attach the drill chuck to the chuck adapter.

(2) The part of the SDS-plus shank is the same as the other

tools. Therefore, refer to the item of "Mounting the tool"

for attaching it.

Push button

Change lever

Fig. 6

Fig. 7

Change lever

Fig. 8