HIKOKI DH 26PX2 취급 지침 매뉴얼 - 페이지 8

{카테고리_이름} HIKOKI DH 26PX2에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI DH 26PX2 16 페이지.

페이지 인쇄

(3) Turn the change lever to

Then the tool is locked.

7. Using depth gauge (Fig. 14)

(1) Loosen the side handle, and insert the depth gauge into

the mounting hole on the side handle.

(2) Adjust the depth gauge position according to the depth

of the hole and tighten the side handle securely.

Depth gauge

8. How to use the drill bit (taper shank) and the taper

shank adapter

(1) Mount the taper shank adapter to the rotary hammer

(Fig. 15).

(2) Mount the drill bit (taper shank) to the taper shank

adapter (Fig. 15).

(3) Turn the switch ON, and drill a hole in prescribed depth.

(4) To remove the drill bit (taper shank), insert the cotter

into the slot of the taper shank adapter and strike the

head of the cotter with a hammer supporting on a rests

(Fig. 16).

Drill bit

Taper shank adapter

mark (Fig. 11).

Side handle

Mounting

hole

Fig. 14

Front cap

Grip

Fig. 15

Cotter

Rest

Fig. 16

9. Make sure to securely hold the tool as shown in

Fig. 17 during operation.

10. Installing the side handle (Fig. 18)

HOW TO USE THE CORE BIT

(FOR LIGHT LOAD)

When boring penetrating large holes use the core bit (for

light loads). At that time use with the center pin and the core

bit shank provided as optional accessories.

1. Mounting

CAUTION

Be sure to turn power OFF and disconnect the plug from

the receptacle.

(1) Mount the core bit to the core bit shank (Fig. 19).

Lubricate the thread of the core bit shank to facilitate

disassembly.

Core bit

Thread

Core bit shank

Fig. 17

Fig. 18

Fig. 19