GAME SolarPRO 4721 소유자 매뉴얼 - 페이지 4
{카테고리_이름} GAME SolarPRO 4721에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAME SolarPRO 4721 12 페이지. Curve heater
GAME SolarPRO 4721에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지)
페이지 인쇄
1.
SAFETY WARNINGS
READ ALL WARNINGS BELOW.
•
Carefully read and adhere to all CAUTION and NOTE notices located throughout this manual.
Failure to comply with these instructions can cause serious injury, death, or damage to the unit.
•
Do NOT allow children to operate this product.
•
Always turn the filter system to a setting that does not allow flow to the pool return when installing
or working on the SolarPRO.
•
Install product away from the pool to prevent children from using the SolarPRO as a way to access the pool.
•
NEVER service this unit with the pool pump running.
•
Do not use any petroleum based lubricant. Only use pool and spa silicon based lubricant on this product.
THESE CAUTION WARNINGS ARE NOT INTENDED TO INCORPORATE ALL POSSIBLE INSTANCES FOR RISK AND/OR SEVERE
INJURY. THE POOL OWNER SHOULD ALWAYS EXERCISE CAUTION WHEN UTILIZING THEIR SWIMMING POOL AND OPERAT-
ING EQUIPMENT.
2.
GENERAL INFORMATION
This manual provides important information relating to the installation, maintenance, and use of the SolarPRO unit.
The installation instructions assume the SolarPRO unit is for use on an already filled, above ground pool that has the following:
1. A pump-oriented water filtration system.
2. The necessary hoses to feed water from the pool into the water filtration system and from the water filtration system to
the pool.
How It Works
When properly installed, the SolarPRO will be connected to your filter and your pool by two hose connections: One hose will feed cold,
filtered pool water from your pump into one port of the SolarPRO. The other hose will feed sun warmed water from the other port of
the SolarPRO to your pool via the pool return inlet in your pool. As cold water is fed into the SolarPRO, it travels through the solar coils
where it is heated by the sun before it is delivered back into your swimming pool.
Unpacking Your SolarPRO
Carefully remove the product and all component parts from the box. Make certain all parts are present before beginning assembly
(see Section 2, Parts List/Reference).
Tools & Equipment Required
The following items are not included with your new SolarPRO, but will be required for proper installation and operation:
•
#2 Phillips screwdriver
•
¼" Flat head screwdriver
•
Silicone based lubricant
Know Your Pool
Before you begin installation it is a good idea to know certain specifications about your pool:
The water volume (in gallons) of the pool.
What size hose does it use? (i.e. 32mm, 38mm or 40mm)
What kind of hose connection does your pool use? (i.e. threaded/unthreaded)
What location will position the SolarPRO for maximum sun exposure?
SAVE THESE INSTRUCTIONS
4