GAME SolarPRO 4721 소유자 매뉴얼 - 페이지 5

{카테고리_이름} GAME SolarPRO 4721에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAME SolarPRO 4721 12 페이지. Curve heater
GAME SolarPRO 4721에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지)

페이지 인쇄

SolarPRO Location

Your SolarPRO needs to be located on a hard level surface. You will need to position the SolarPRO lower than the pool's water level and

at a safe distance away from the pool (see Section 1, Safety Warnings).

•

The unit(s) should never be placed on the roof of any structure, or above the water level of the pool.

•

The unit(s) should be angled toward the sun using the legs provided. Do not exceed the angle the legs

produces, or 30 degrees from horizontal in any direction.

NOTE: The SolarPRO is to be installed between the filter and the pool water inlet, AFTER the water is filtered. The SolarPRO

must come after the filter to prevent buildup in the tubing.

IMPORTANT: If you are using a chlorine generator OR an in line chlorinator, it must be connected in-line following the SolarPRO

to prevent damage.

CAUTION: BEFORE LOOSENING ANY THREADED CONNECTIONS ON YOUR FILTER, PUMP OR POOL, BE SURE THE SUCTION

AND PRESSURE HOSES ON THE FILTER ARE CLOSED OR BLOCKED TO PREVENT WATER FLOW.

IMPORTANT: To reduce heat loss, use a pool cover on your pool overnight.

PARTS LIST/REFERENCE

Main Unit (1)

Flat Gasket (2)

40mm Adapter with O-Ring (2)**

Only used with 40mm

threaded hoses

*Compatible with most Bestway pools.

**Compatible with most Intex pools.

32mm to 38 mm Hose Reducer (2)

Collar and Hose Adapter*

32mm-38mm

Filter Hose (2) with O-Ring (2)

Note: Some parts may be pre-installed at the factory. Parts not shown to scale.

Hose Clamp (2)

Teflon Tape (1)

SAVE THESE INSTRUCTIONS