Airetool EIC-625-750 운영 및 서비스 매뉴얼 - 페이지 13

{카테고리_이름} Airetool EIC-625-750에 대한 운영 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airetool EIC-625-750 16 페이지. Tube cutters

POINTS FOR GOOD TUBE CUTTING

1. KEEP BITS COOL -

This will extend the bits life. It possible, use a flushing system of air and some type of good

cutting fluid.

2. DO NOT FORCE FEED -

To much pressure of the tool bits can cause the bits to puncture thru the tube wall which

may cause the bits to break.

3. KEEP BIT AND MANDREL AREA CLEAN OF CHIPS -

Cleaning of the chips from the area of the tool bits

and mandrel will allow for free movement of both. Chips in this area can cause the mandrel and or tool bits to bind and break.

4. SHARPEN TOOL BITS -

Sharpen tool bits, per above specifications, before they are allowed to wear and overheat.

Overheating will remove the temper from the tool bit so that sharpening will not last very long. KEEP BITS COOL !

5. TOOL BIT SELECTION -

Feed angels of the tool bit are very important for the type of material that is being cut. Be

sure that you are using the proper tool bits!

6. PROPER CUTTING SPEED -

This is very important for proper cutting and for tool bit life. See R.P.M. recommenda-

tions on page 18 in this manual.

Page - 13