HIKOKI WR18DH 취급 지침 매뉴얼 - 페이지 9
{카테고리_이름} HIKOKI WR18DH에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI WR18DH 20 페이지.
페이지 인쇄Power Output
Wh
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the
USB device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life of a
USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
PRECAUTIONS REGARDING THE
DUST-RESISTANCE AND WATER-
PROOFING FUNCTIONS
This product conforms to IP56 protection class ratings
(dust-resistance and water-proofing) for electrical
equipment as stipulated by the international IEC
regulations. (Only the main unit conforms to the IP56
protection class ratings when equipped with a battery.)
[Descriptions of IP Codes]
IP56
Protection rating for water penetration
Must be no adverse effects on the equipment
when sprayed with powerful jets of water from all
directions (water-proofed).
5
(100 L of water per minute sprayed for
approximately three minutes from a distance of
approximately three meters with the use of a spray
nozzle with a diameter of 12.5 mm.)
Protection rating for external assault by solid
objects
Dust that may cause adverse effects on the
equipment must not be able to enter (dust-
resistance).
6
(The equipment to be left non-operable in a test
chamber in which particles of talcum powder with
a diameter of less than 75 μm are floating in the air
with the use of an agitation pump at a rate of 2 kg
per cubic meter for eight hours.)
The equipment has been designed to withstand the effects
of dust and water, but there is no guarantee that it will not
malfunction. Do not use or leave the equipment in locations
where it is subject to excessive amounts of dust, or in
locations where it is submerged in water or subject to
rainwater.
NAMES OF PARTS
The numbers in the list below correspond to Fig. 1–Fig. 16.
1
Protector
2
Anvil
3
Friction ring
4
LED light
5
Trigger switch
6
Switch panel
7
Battery
8
Hook
9
Handle
10
Push button
11
Motor
12
High / Low mode selector switch
13
High / Low mode indicator lamp
14
Auto stop mode selector switch
15
Auto stop mode indicator lamp
16
Latch
17
Charge indicator lamp
18
Pilot lamp
19
Groove
20
Screw
21
1/2" Drive hex. socket
22
O-ring
23
Pin
24
Display panel
25
Battery level indicator switch
26
Battery level indicator lamp
9