HIKOKI WR27A 취급 지침 매뉴얼 - 페이지 3

{카테고리_이름} HIKOKI WR27A에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI WR27A 12 페이지.

페이지 인쇄

General

Before each use:

Always operate, inspect and maintain tool in accordance with all regulations (local, state,

●

federal and country), that may apply to hand held pneumatic tools.

Drain water from air compressor tank and condensation from air lines. See air

●

compressor's operation manual.

Disconnect the tool from the air supply before lubricating,

CAUTION

installing, removing or adjusting the tool.

Lubricate tool, see "Maintenance" section in this manual.

●

Select the required drilling bit depending on the material to be work on .

●

Connect tool to air hose of recommended size.

●

NOTE: The use of a quick connect set makes connecting easier.

IMPORTANT

The use of air filters and air line lubricators is recommended.

To use:

Turn air compressor on and allow air tank to fill.

●

Set the air compressor's regulator to 90 PSI (6.2 bars). This tool operates at a maximum 90 PSI

●

(6.2 bar) pressure.

For rotating tools, make sure the direction of rotation before operating tools.

●

Make sure the inserted tool is firmly secured by the chuck (drill/tappers), by the retainer

●

(hammers/needle scalers), by the bit holder (screwdrivers), by the collet (die grinders), by

the flange set (grinders), blade holder (saws) or firmly attached to the anvil (impact/ratchet

wrenches) or the pad (sanders/polishers).

Setting for the rotational direction, if any:

●

Pull the level/switch as it is marked on the tool.

「F」(Forward) - Clockwaise direction seen from the operator 's position.

◆

「R」(Reverse) - Counter-clockwaise direction seen from the operator's position.

◆

Note: For some tools, it may marked with the combination of 「L」and「R」. In this case,

「R」(right) indicates the forward direction and 「L」(Left) indicates the reverse

direction.

Setting for the rotating/reciprocating speed settings, if any:

● ●

by digits: greater number indicates a hight setting and vice versa.

◆

by symbols: greater size of the symbol indicates a hight setting and vice versa.

◆

Note: Always start operating with a lower setting.

Allow the tool to stop completely before changing the direction of rotation.

●

To Start or Stop

●

The tool equips with a hold -to-run trigger/level. Pull the trigger (or press down the lever) to

start the tool. The tool will stop running when t he trigger/lever is released.

Note: For certain kinds of air tools, it might take some seconds for the tool to stop

completely because of the inertia.

OPERATION INSTRUCTION