HIKVISION D7T Series 사용자 설명서 - 페이지 4

{카테고리_이름} HIKVISION D7T Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION D7T Series 12 페이지. Bullet & turret camera
HIKVISION D7T Series에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

페이지 인쇄
HIKVISION D7T Series 사용자 설명서

2 Installation

Before you start:
 Please make sure that the device in the package is in
good condition and all the assembly parts are
included.
 Make sure that all the related equipment is power-off
during the installation.
 Check the specification of the products for the
installation environment.
 Check whether the power supply is matched with
your required output to avoid damage.
 Please make sure the wall is strong enough to
withstand three times the weight of the camera and
the mounting.
 If the wall is the cement wall, you need to insert
expansion screws before you install the camera. If the
wall is the wooden wall, you can use self-tapping
screw to secure the camera.
 If the product does not function properly, please
contact your dealer or the nearest service center. Do
not disassemble the camera for repair or
maintenance by yourself.
2.1 Installation of Type I Camera
Both wall mounting and ceiling mounting are suitable for the
bullet camera. Ceiling mounting will be taken as an example in
this section. You can take steps of ceiling mounting as a
reference if wall mounting is adopted.
2.1.1 Ceiling/Wall Mounting without Gang Box
Steps:
1. Attach the drill template (supplied) to the place
where you want to fix the camera, and then drill the
screw holes and the cable hole in the ceiling/wall
according to the drill template.
Screw Hole
2. Route the cables through the cable hole.
3. Secure the camera to the ceiling with the supplied
Screws.
Figure 2-2 Fix the Camera to the Ceiling
Screw Hole
template
Figure 2-1 Drill Template

Adjusting Screws

Screw
Hole
Trim Ring
Fixing Screw