HIKVISION D7T Series 사용자 설명서 - 페이지 5
{카테고리_이름} HIKVISION D7T Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION D7T Series 12 페이지. Bullet & turret camera
HIKVISION D7T Series에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)
페이지 인쇄
4. Connect the corresponding cables.
5. Adjust the camera according to Figure 2-3 to get an
optimum angle.
1). Loosen the P screw to adjust the pan direction
[0°~360°]. Tighten the screw after completing
the adjustment.
2). Loosen the T screw to adjust the tilt direction
[0°~180°]. Tighten the screw after completing
the adjustment.
3). Loosen the R screw and rotate the camera
[0°~360°] to adjust the lens to the surveillance
angle. Tighten the screw after completing the
adjustment.
Rotation Position Range
[0°-360°]
6. Tighten the fixing screws and the trim ring to fix the
camera.
2.1.2 Ceiling/Wall Mounting with Gang Box
You need to purchase a gang box separately if you adopt celling
mounting.
Steps:
1. Take apart the gang box and align the screw holes of
the bullet camera and the gang box cover.
2. Route the cables through the cable hole of gang box
and fix the camera with the gang box cover with the
supplied screws, as shown in Figure 2-4.
Figure 2-4 Fix the Camera with the Gang Box
3. Drill the screw holes in the ceiling/wall according to
the supplied drill template.
4. Hammer the supplied screws into the screw holes to
fix the gang box to the ceiling/wall.
Figure 2-3 3-axis Adjustment
Gang Box Cover
Screw
Pan Position Range
[0°-360°]
P Screw
Tilt Position Range
[0°-180°]
T Screw
R Screw