Majacraft Aura 사용 설명서 - 페이지 8

{카테고리_이름} Majacraft Aura에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Majacraft Aura 16 페이지.

7. Drive Bands

Required:

1 - Green Flyer Drive band (in the hardware bag)

1 - Black Bobbin Drive band (in the hardware bag)

The green drive band goes on the

lacquered grooves on the drive wheel

and then through one of the grooves on

the flyer whorl.

There are detailed instructions at the end

of this document for setting the bobbin

drive band tension.

8. Crank Assembly

Required:

3 - Silver 32mm (1 1/4") screws (in the hardware bag)

Posidrive screwdriver

The black Bobbin Drive non-stretch band goes round the black groove

on the drive wheel, the small idler pulley on the tension adjust and then

over one of the black grooves on the bobbin drive whorl.

The drive wheel has been

predrilled with the holes for

the aluminium crank assembly.

You will need a posi-drive

screwdriver and the three 32mm silver screws. Make sure the drive belts are on.

Align the holes on the drive

wheel with the holes in the crank

assembly and screw it into place

using the silver 32mm screws. It is

recommended that you insert the

centre screw first.

majacraft