Majacraft Aura 사용 설명서 - 페이지 10

{카테고리_이름} Majacraft Aura에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Majacraft Aura 16 페이지.

EXTRA

If you are not certain of the connection arrangement, here is a full

description.Place the wheel directly in front of you so you are looking at

the crank assembly attached to the drive wheel. The rubber joiner that

is on the conrod/footman that is closest to you goes into the hole in the

pedal on your left. The joiner on the conrod that is furthest from you

goes into the hole in the pedal that is on your right.

10. Bobbin and Flyer

Required:

1 - Wooden Bobbin

1 - Aura flyer

If you have some petroleum jelly or vaseline, rub a small smear onto the flyer shaft. This has already been

done at the factory so is not essential. Now slide the bobbin on.

If you look at the Aura bobbin end that has the blackened tension

groove, you will notice two small holes near the flyer shaft hole. These

holes are to locate on the drive pins embedded in the Aura drive system

on the head. This end of the bobbin must go on the flyer shaft first and

the holes align with the pins in the drive system.

10b

10c

10a

10d

majacraft