Majacraft M WH ROSE 사용 설명서 - 페이지 4

{카테고리_이름} Majacraft M WH ROSE에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Majacraft M WH ROSE 12 페이지.

Turn the handle assembly over so the small threaded hole near the handle pivot is on the bottom and

position the handle so it makes a 90 degree angle between the stem and handle. Using the T wrench,

carefully screw the 25mm JCB bolt in until it is tight.

3. Attach stem to base assembly

Required:

3 - M6 30mm JCB (1 1/8") bolts (in the hardware bag)

4mm allen T wrench (in the hardware bag)

Stem/Handle assembly

Base assembly

Position the Base assembly on the flat surface. Now slide the Stem/

Handle assembly into the Base assembly and carefully align the stem

holes with the base side plate holes and the brace hole with the hole

underneath the base assembly.

Insert the JCB bolts through the holes and into the stem assembly.

Turn the base over and insert the JCB bolt in the hole underneath.

Partially tighten the bolts, checking that they are threaded in

correctly before finally tightening all bolts.

majacraft