CentralPneumatic 68019 설정 및 운영 지침 매뉴얼 - 페이지 13
{카테고리_이름} CentralPneumatic 68019에 대한 설정 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CentralPneumatic 68019 19 페이지. 2-in-1 18 gauge nailer-stapler
CentralPneumatic 68019에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)
페이지 인쇄
USER-MAINTENANCE
User-Maintenance Instructions
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FROM ACCIDENTAL OPERATION,
BEFORE ANY MAINTENANCE OR
REPAIRS ARE DONE (including
clearing jams):
• Wear ANSI-approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
• Release the Trigger.
• Detach the air supply.
• Attempt to fire the Tool into a
piece of scrap wood to ensure
that it is incapable of firing any
fasteners.
• Empty the magazine and leave
it open during service. The
Magazine is spring-loaded and
may cause parts or a fastener to
fly out of the Tool.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE: Do not
use damaged equipment. If
abnormal noise, vibration, or air
leaks are detected, have problem
corrected before further use.
TO PREVENT EXPLOSION:
Lubricate only with specified
lubricants. Lubricate the air inlet
using only pneumatic tool oil.
Lubricate the internal mechanism
using only white lithium grease.
Other lubricants may damage the
mechanism and may be highly
flammable, causing an explosion.
SKU 68019
TO PREVENT
SERIOUS INJURY
For technical questions, please call 1-800-444-3353.
Note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular operation
of the air-operated tool.
Daily - Air Supply Maintenance:
Every day, perform maintenance on the
air supply according to the component
manufacturers' instructions. If equipped
with a lubricator, the oil level needs to be
maintained and the moisture filter must
be regularly drained. Performing routine
maintenance on the air supply will allow
the tool to operate more safely and will
also reduce wear on the tool.
Clearing Jams
FROM ACCIDENTAL OPERATION,
BEFORE ANY MAINTENANCE OR
REPAIRS ARE DONE (including
clearing jams):
• Wear ANSI-approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
• Release the Trigger.
• Detach air supply.
• Attempt to fire the Tool into a
piece of scrap wood to ensure
that it is disconnected and is
incapable of firing any fasteners.
• Empty the magazine and leave
it open during service. The
Magazine is spring-loaded and
may cause parts or a fastener to
fly out of the Tool.
1.
If a fastener is jammed in the discharge
area, remove it with pliers.
2.
If a fastener is jammed in the Magazines,
depress the Latch (64) and pull back
on the Moveable Magazine (55), and
TO PREVENT
SERIOUS INJURY
Page 13