CentralPneumatic 68019 설정 및 운영 지침 매뉴얼 - 페이지 14
{카테고리_이름} CentralPneumatic 68019에 대한 설정 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CentralPneumatic 68019 19 페이지. 2-in-1 18 gauge nailer-stapler
CentralPneumatic 68019에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)
페이지 인쇄
remove the Position Seat (54). Then pull
out of Fixed Magazine (52).
3.
Pull out the jammed fastener and the
remainder of the fastener strip that is
still in the magazine. Dispose of the
remaining fastener strip; it may be bent
or damaged in some other way.
4.
If a fastener is jammed in the Drive
Guide (40), pull out the Quick Release
Lever (44) and disengage the Quick
Release Spring (45).
5.
Remove the jammed fastener; pliers
maybe necessary to remove a stuck
fastener.
6.
Inspect the Drive Guide for any bends or
breakage. If it is damaged, do not use
the tool until it is repaired by a qualified
technician.
7.
Lightly oil the Drive Guide, engage the
Quick Release Spring, and snap the
Quick Release Lever back into place.
8.
Make sure that the Safety Tip moves
smoothly without binding.
9.
Reload the Nailer/Stapler and then
reconnect it to the air supply.
10. Press the Safety of the Nailer/Stapler
against an appropriate piece of scrap
wood.
11. Test fire the Nailer/Stapler several times,
checking for proper operation.
12. Disconnect the Nailer/Stapler, remove
the fasteners, and store in a location out
of children's reach.
13. If you are unable to clear the fastener
jam using the method prescribed above,
the tool should be taken to a qualified
service technician for proper servicing.
Page 14
For technical questions, please call 1-800-444-3353.
SKU 68019