AirFiltronix HS3000A4 조립 및 설치 지침 - 페이지 2

{카테고리_이름} AirFiltronix HS3000A4에 대한 조립 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AirFiltronix HS3000A4 5 페이지. Room air purifier

1. Unpack the HS3000A4 blower unit and check for shipping damage.

Place on table or portable cart approximately 32-34" high. (see Figure 1).

2. Unsnap latches on either side of the blower enclosure ( see figure 1) and lift the blower unit off its base (see figure 2).

Remove the line cord packaged inside the enclosure and loosen the wingnuts on either side of the compression bar

until the bar can be lifted approximately 4-5 inches above the filter frame (see figure 3). Place blower base on top of

enclosure allowing the two 8" openings in underside of blower base to sit over the two 8" collars with closed cell

gaskets on top of the enclosure.

Figure 2

Unpack the filters supplied with the unit (see appendix A) and lift the compression bar. Install filter(s) into the filter frame

with its gasketed side down (see figure 4).

HS3000A4 Room Air Purifier Installation Instructions

Figure 1

Figure 4

Figure 3