Centrica Modbus TCP 프로그래머 매뉴얼 - 페이지 14

{카테고리_이름} Centrica Modbus TCP에 대한 프로그래머 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Centrica Modbus TCP 14 페이지.

Configure the bridge Pulse interface

1. Navigate to the 'Pulse Setup' tab

2. Enable pulse input 1, 2 or both

3. Enabled pulses are made available for Modbus TCP base on the 'Connection Setup' >

'Enable Modbus TCP' value and are sent to PowerRadar based on the 'Connection Setup' >

'Connect to PowerRadar' value.

The bridge contains three hardware LED indicators that change based on bridge operations.

Fort a full list of led indication states, please refer to the

below refers to changes in LED behavior in stand-alone mode.

In a 'Standalone mode' the bridge's middle LED (network LED) supports the following behavior:

•

Yellow blinking until local network connection (Ethernet or Wi-Fi) is established (same as in

'PowerRadar' mode).

•

Green, 1-sec blink if local network connection is established but no Modbus connection

from a master device detected.

•

Solid green when a Modbus master device connection is detected.

There is no change in LED behavior when in 'PowerRadar' or 'Combined' modes.

Figure 9 Pulse Setup Tab

Gen 4 Bridge User

Guide. The information