Centrica Modbus TCP Руководство программиста - Страница 14

Просмотреть онлайн или скачать pdf Руководство программиста для Сетевое оборудование Centrica Modbus TCP. Centrica Modbus TCP 14 страниц.

Печатать страницу

Configure the bridge Pulse interface

1. Navigate to the 'Pulse Setup' tab
2. Enable pulse input 1, 2 or both
3. Enabled pulses are made available for Modbus TCP base on the 'Connection Setup' >
'Enable Modbus TCP' value and are sent to PowerRadar based on the 'Connection Setup' >
'Connect to PowerRadar' value.

Bridge led configuration for stand-alone mode

The bridge contains three hardware LED indicators that change based on bridge operations.
Fort a full list of led indication states, please refer to the
below refers to changes in LED behavior in stand-alone mode.
In a 'Standalone mode' the bridge's middle LED (network LED) supports the following behavior:
•
Yellow blinking until local network connection (Ethernet or Wi-Fi) is established (same as in
'PowerRadar' mode).
•
Green, 1-sec blink if local network connection is established but no Modbus connection
from a master device detected.
•
Solid green when a Modbus master device connection is detected.
There is no change in LED behavior when in 'PowerRadar' or 'Combined' modes.
Figure 9 Pulse Setup Tab
Gen 4 Bridge User
Guide. The information