Bristan Descent DSC FSBSM C 설치 지침 매뉴얼 - 페이지 9
{카테고리_이름} Bristan Descent DSC FSBSM C에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Descent DSC FSBSM C 16 페이지. Tap
Bristan Descent DSC FSBSM C에 대해서도 마찬가지입니다: 설치 지침 및 사용자 설명서 (16 페이지)
페이지 인쇄
Installation
Basin Mixer / 1 Hole Bath Filler
1. Screw the flexi tails into the bottom of
the body by hand only (DO NOT
OVERTIGHTEN).
2. Feed the flexi tails through the hole
in the basin / bath, ensuring the washer
is fitted between the tap body and fixing
surface to ensure a water tight seal.
3. Screw the fixing rods into the bottom
of the tap body. Slide the 'C' shaped
rubber washer and 'C' shaped metal
washer onto the fixing rods up to the
underside of the basin / bath.
4. To secure the tap body in place tighten
the fixing nuts onto the fixing rods until
the are fully tightened against the
'C' shaped metal washer. The fixing nuts
can be tightened with a suitable spanner.
5. Connect the flexi tails to the hot and
cold water supplies.
6. Turn on both water supplies,
operate the handle in both directions,
letting the water flow for a few minutes to
flush through the system.
7. Fit the clicker waste (for basin mixer
only) ensuring the rubber washer is fitted
between the basin and the waste. Place
the other rubber washer under the basin
and secure by tightening the backnut, in
order to fill the basin, the button in the
middle of the waste needs to be pressed
down. To release the water, press the but-
ton again.
8. Check all joints and connections for any
leaks.
Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.
9