Bristan DSC 3HBF C 설치 지침 및 사용자 설명서 - 페이지 4

{카테고리_이름} Bristan DSC 3HBF C에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan DSC 3HBF C 18 페이지. Descent tap range
Bristan DSC 3HBF C에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (16 페이지)

페이지 인쇄

General Information

This product has been designed to comply with BS EN 200 for combination

taps to be used within systems designed to BS 6700.

BS 6700 recommends the temperature of stored water should never exceed

65°C. A stored water temperature of 60°C is considered sufficient to meet all

normal requirements and will minimise the build up of lime scale in hard water

areas.

If installing this product on a low pressure (tank fed) system please see

specification table below to determine the minimum distance required from

underside of the cold water tank to the outlet.

These taps and mixers should be installed in compliance with the Water

Regulations. Where the supplies are unbalanced, i.e. Hot water from cylinder

tank/cold from the mains, approved check valves must be fitted in the supply

pipes.

For further details contact your Local Water Authority.

Specifications

P r o d u c t

Code

DSC 3HBAS C

DSC 3HBF C

DSC WMBAS

DSC WMBF C

DSC BS C

Maximum static pressure: 10.0 bar

System Requirements:

Gravity fed hot & cold (Equal pressures)

Gravity fed hot & cold (Differential pressure, maximum ratio 5:1)

Unvented systems

Instantaneous water heater (Combination boiler)

Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.

Working

Pressures

Min

Max

0.2

5.0

15mm Compression

Threaded Tail

0.4

5.0

3/4" BSP Threaded Tail

0.2

5.0

15mm Compression

Threaded Tail

0.5

5.0

22mm Compression

Threaded Tail

0.2

5.0

1/2" BSP Threaded Tail

Minimum distance

from cold water

Inlet

tank to outlet

(metres)