Airflex5D AF5D-20 사용자 설명서 - 페이지 6

{카테고리_이름} Airflex5D AF5D-20에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflex5D AF5D-20 17 페이지. 2d/3d multi-projector stacking processor

7.3 Procedures for 3D Display Setting in AF5D
If still can't verify "R" & "L" characters in both eyes, please check below again:
1. Is the screen for 3D display?
2. Are the Glasses and polarizers the same types and paired for the RH & LH eyes?
3. AF5D for RH eye should connect to RH eye projector and LH AF5D should connect to LH eye projector.
Please check from [Output Format] menu and make sure to have correct settings. If the connection is
incorrect, please use [Output Frame] setting to change the connection for RH/LH eyes. Don't change the
connection cables. Otherwise geometry settings should be re-aligned again.
4. Is the Blue Ray player set to [Auto 3D] or [1080p @24Hz] mode to deliver 3D signal out?
5. If Side by Side or Top-Bottom 3D formats are used, please check the aspect ratio in video source output
to make sure AF5D will receive full screen image.
6. Is there any DVI/HDMI or signal source compatibility issue and only one projector shows image?
7. Are the DVI/HDMI cables qualified and the length not too long?
7. Warp and Geometry Correction of the Image
Each function in OSD menu may not co-exist. [4 Corner] adjustment can replace [Keystone] function. Inside
[Warp] menu, there is [Shift] function for 4 corner position adjustment. When [Warp] Menu is activated, [4
Corner] function will be disabled. While curved display is required, please activate [Warp] menu to adjust 4
corner positions by [Shift] menu and image curve by [Corner], [Edge] or [Center] Menu.
1. After image alignment, to activate [3D Properties]
menu and select [Input Format].
2. Select [Automatic] if the 3D signal is standard 3D
formats from Blue Ray player or sources with 3D
index inside the signal.
3. Select [Side By Side] or [Top-Bottom] based on
user's 3D input source.
1. To set [Output Format] and set RH eye AF5D
with [Right Eye Frame] and LH eye AF5D with
[Left Eye Frame] output format.
2. If the input is 1080p 24Hz and the projectors can
also support this signal, please select [Enable] in
[1080p 24Hz Output] menu in both RH/LH AF5D
to get the best 3D performance
1. Activate [Identify] menu to show "R &
L" characters on the screen
simultaneously to verify the final 3D
settings in the system.
2. RH eye should see only "R" and LH
eye should see only "L".
5