Airflex5D AF5D-20 User Manual - Page 6

Browse online or download pdf User Manual for Computer Hardware Airflex5D AF5D-20. Airflex5D AF5D-20 17 pages. 2d/3d multi-projector stacking processor

Print Page

7.3 Procedures for 3D Display Setting in AF5D

If still can't verify "R" & "L" characters in both eyes, please check below again:

1. Is the screen for 3D display?

2. Are the Glasses and polarizers the same types and paired for the RH & LH eyes?

3. AF5D for RH eye should connect to RH eye projector and LH AF5D should connect to LH eye projector.

Please check from [Output Format] menu and make sure to have correct settings. If the connection is

incorrect, please use [Output Frame] setting to change the connection for RH/LH eyes. Don't change the

connection cables. Otherwise geometry settings should be re-aligned again.

4. Is the Blue Ray player set to [Auto 3D] or [1080p @24Hz] mode to deliver 3D signal out?

5. If Side by Side or Top-Bottom 3D formats are used, please check the aspect ratio in video source output

to make sure AF5D will receive full screen image.

6. Is there any DVI/HDMI or signal source compatibility issue and only one projector shows image?

7. Are the DVI/HDMI cables qualified and the length not too long?

7. Warp and Geometry Correction of the Image

Each function in OSD menu may not co-exist. [4 Corner] adjustment can replace [Keystone] function. Inside

[Warp] menu, there is [Shift] function for 4 corner position adjustment. When [Warp] Menu is activated, [4

Corner] function will be disabled. While curved display is required, please activate [Warp] menu to adjust 4

corner positions by [Shift] menu and image curve by [Corner], [Edge] or [Center] Menu.

1. After image alignment, to activate [3D Properties]

menu and select [Input Format].

2. Select [Automatic] if the 3D signal is standard 3D

formats from Blue Ray player or sources with 3D

index inside the signal.

3. Select [Side By Side] or [Top-Bottom] based on

user's 3D input source.

1. To set [Output Format] and set RH eye AF5D

with [Right Eye Frame] and LH eye AF5D with

[Left Eye Frame] output format.

2. If the input is 1080p 24Hz and the projectors can

also support this signal, please select [Enable] in

[1080p 24Hz Output] menu in both RH/LH AF5D

to get the best 3D performance

1. Activate [Identify] menu to show "R &

L" characters on the screen

simultaneously to verify the final 3D

settings in the system.

2. RH eye should see only "R" and LH

eye should see only "L".