Airflow 7005A 설치 지침 - 페이지 2

{카테고리_이름} Airflow 7005A에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow 7005A 2 페이지. Maxair window exhaust fans

페이지 인쇄

7005A & 7007A

"A" Internal clamp

sub-assembly

• Make sure the external seal is against the

glass, align and insert the bolts.

• Brass nuts supplied should be connected

and finger tightened only.

Apply soap to

the foam seal

Fan assembly

MaxAir Window Exhaust Fan Installation Instructions

• Cut hole in glass 212mm Ø ± 2.0mm.

• Locate internal clamp sub-assembly

"A", slide over your arm as shown.

• Locate external clamp sub-assembly

"B", fold and insert through the hole in the

window pane.

"B" External clamp

sub-assembly

Finger

tighten

only

• If required, apply liquid or similar soap

to foam seal on inside of external clamp

sub-assembly.

• Carefully slide cylindrical window

grille outlet end of fan assembly

through opening.

• With screws provided, attach fan assembly

to window clamp assembly (four places).

7005A & 7007A

Screws labelled 1, 2, 3 retain the

terminal cover to the chassis

• Place cover assembly as shown.

• Tighten retaining screw.

• Test. Ready to go.

• This appliance is not intended

for use by children or infirm

persons without supervision.

• Children should be supervised

to ensure they do not play with

the appliance.

• Fan should be mounted 2.3m

above the floor.

• Appliance intended for exterior

window mounting only.

MaxAir Window Exhaust Fan Installation Instructions

Break tab for

cable access

• Remove termination cover (screws

labelled with 1, 2, 3). Electrician to make

electrical connection. (3 core flex,

7mm Ø [17/64"] specified).

• Stripped ends to be kept to a minimum.

• Cable (3 core flex) to be placed as shown

below in wiring diagram.

• Replace termination cover.

Retaining

screw