BRISTERS Chuck Wagon Soft Cab Enclosure 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} BRISTERS Chuck Wagon Soft Cab Enclosure에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BRISTERS Chuck Wagon Soft Cab Enclosure 2 페이지.

4. Adjust door by moving clamps to desired area.

Tighten nuts & bolts. Follow same procedure for

opposite door.

5. Slide skin over cage and secure Velcro

around framing. Remove door framing and

fasten Velcro onto framing.

7. To re-install windshield, punch holes into fabric to align with

holes into cage. Insert the windshield screws from the back (nuts on

outside). Position top flap to determine where Velcro will be

attached to the under side of the top lip or windshield. Cut & attach

Velcro. Secure top flap to windshield with Velcro.

8. A flap is provided to seal bottom of

windshield. Position flap to determine

where self adhesive Velcro will be

attached. Cut Velcro to size and apply

across hood and lower windshield.

Secure flap.

9. If you plan to install the optional ABS plastic hard top,

you will need to punch holes into fabric to align with

clamps and re-secure with mounting hardware. Brister's

recommends closing the doors on the outside of the top.

Or, you can trim the top to clear the doors if you prefer:

A. Remove the black edge trim from the top.

B. Protect the sides of the top with masking tape.

C. Trace around the door with a pencil on the tape.

D. Remove the top and cut along line with a jig saw.

E. Re-install top and edge trim.

Shown with optional back cap (not included)