BRISTERS Chuck Wagon Soft Cab Enclosure Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Автомобільні аксесуари BRISTERS Chuck Wagon Soft Cab Enclosure. BRISTERS Chuck Wagon Soft Cab Enclosure 2 сторінки.
Друкувати сторінку4. Adjust door by moving clamps to desired area.
Tighten nuts & bolts. Follow same procedure for
opposite door.
5. Slide skin over cage and secure Velcro
around framing. Remove door framing and
fasten Velcro onto framing.
7. To re-install windshield, punch holes into fabric to align with
holes into cage. Insert the windshield screws from the back (nuts on
outside). Position top flap to determine where Velcro will be
attached to the under side of the top lip or windshield. Cut & attach
Velcro. Secure top flap to windshield with Velcro.
8. A flap is provided to seal bottom of
windshield. Position flap to determine
where self adhesive Velcro will be
attached. Cut Velcro to size and apply
across hood and lower windshield.
Secure flap.
9. If you plan to install the optional ABS plastic hard top,
you will need to punch holes into fabric to align with
clamps and re-secure with mounting hardware. Brister's
recommends closing the doors on the outside of the top.
Or, you can trim the top to clear the doors if you prefer:
A. Remove the black edge trim from the top.
B. Protect the sides of the top with masking tape.
C. Trace around the door with a pencil on the tape.
D. Remove the top and cut along line with a jig saw.
E. Re-install top and edge trim.
Shown with optional back cap (not included)