Gamma 5003 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Gamma 5003에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 5003 19 페이지. 6 point mounting
Gamma 5003에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

1. Tension Calibration

STRINGING THE FRAME

Clamp Base Operation

Rotate the Base Locking Lever clockwise to secure the

clamp base to the turntable.

Reverse the clamping procedure to unlock the string

clamp. The Locking Lever is spring loaded to assist the

unlocking of the clamp base.

The Locking Lever should be tightened enough to pre-

vent clamp base slippage on the turntable, when the

desired tension is placed on the string. To go from the

loose position to the clamped position and back, gener-

ally requires the rotation permitted by the slot in th clamp

base. If the rotation is not sufficient to allow smooth

operation of, adjust the Clamp Base Locking Nut as

outlined below.

Note: If the string slips in the string clamp while tensioning,

adjust the gap between the clamp jaws as per the

following instructions.

Clamping the First Main String

To begin stringing the main strings, thread the two ends

of the string through the two center holes at the appro-

priate end of the frame and continue through the oppo-

site center holes. Thread one end of the string through

the adjacent grommet hole and pull excess by hand.

Secure one of the strings using a string clamp.

Pulling Tension

Wrap the loose section of string once around the roller

guide and insert the string between the diamoind dust

coated string gripper plates. Pull the string perpendicu-

lar to the gripper plates while slowly rotating the tensioner

crank clockwise until the brake lever pops out of the

latching block. The string is now tensioned and can be

clamped in place with the remaining fixed clamp.

Repeat the above steps until all main strings are in-

stalled. Tie off ends of main strings as per racquet

manufacturers recommendations.