Gamma 6002 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Gamma 6002에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6002 20 페이지.
페이지 인쇄ASSEMBLY INSTRUCTIONS
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3 mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the button
head screw and washer in the end of the
tensioner bar.
Installing the Crank Arm
Remove the flat head screw located on the
crank shaft with the 2.5mm wrench provided.
Slide thecrank handle over the crank shaft
while aligning the holes. Replace the flat-
head screw.
Note: The tensioner bar is equipped with a
tensioner travel stop screw to limit travel of
the tensioner along the bar and prevent con-
tact between the tensioner and the racquet
mounting system while stringing. The stop
screw is located about midpoint along the
tensioner bar below the gear track. To en-
gage the stop, turn the stop screw clockwise
until fully seated against the bar. To disen-
gage the stop screw, turn it counter clock-
wise until it no longer protrudes beyond the
Travel Stop
surface of the bar.
8