Gamma 6002 Manual do Proprietário - Página 9

Procurar online ou descarregar pdf Manual do Proprietário para Máquinas de encordoar Gamma 6002. Gamma 6002 20 páginas.

ASSEMBLY INSTRUCTIONS

Installing the Tensioner

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3 mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the button

head screw and washer in the end of the

tensioner bar.

Installing the Crank Arm

Remove the flat head screw located on the

crank shaft with the 2.5mm wrench provided.

Slide thecrank handle over the crank shaft

while aligning the holes. Replace the flat-

head screw.

Note: The tensioner bar is equipped with a

tensioner travel stop screw to limit travel of

the tensioner along the bar and prevent con-

tact between the tensioner and the racquet

mounting system while stringing. The stop

screw is located about midpoint along the

tensioner bar below the gear track. To en-

gage the stop, turn the stop screw clockwise

until fully seated against the bar. To disen-

gage the stop screw, turn it counter clock-

wise until it no longer protrudes beyond the

Travel Stop

surface of the bar.