Gamma 6004 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Gamma 6004에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6004 20 페이지. 6 point mounting
Gamma 6004에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (19 페이지)

페이지 인쇄

requires the travel permitted by the clamp base. If the travel is not sufficient to allow smooth

operation of, adjust the clamp base as outlined on page 16.

between the clamps and the string to allow for reduced clamping pressure while securing and

holding the string under tension.

knob counterclockwise until the "1" or "2" mark on the knob aligns with the line on the knob

support. To decrease tension by 1 or 2 lbs, turn the knob clockwise until the "2" or "1" mark

on the knob aligns with the line on the knob support.

STRINGING THE FRAME

Clamp Base Operation

Rotate the base locking lever clockwise to

secure the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp. The locking lever is spring

loaded to assist the unlocking of the clamp

base.

The locking lever should be tightened enough

to prevent clamp base slippage on the turn-

table, when the desired tension is placed

on the string. To go from the loose position

to the clamped position and back, generally

Clamp Head Operation

Switch Action Clamps are of a dual action

design where as the clamp head and

clamp base operate independently of one

another.

To clamp a string, lift the clamp head and place

the string between the jaws and depress the

clamp head lever to secure the string. The

clamping pressure applied to the string should

be adjusted to provide sufficient pressure

to secure the string when subjected to the

desired pulling tension. The diamond coated

gripper plates provide for increased friction

Setting Tension

The spring tensioner utilizes a rotary adjust-

ing knob along with a linear tension scale

to indicate the tension setting. The scale is

divided into 3 lb. increments and each 1/3

turn of the tension knob changes tension

by 1 lb. To set the desired tension, rotate

the tension knob and align the mark on the

spring guide with the desired tension setting

on the scale. When the "0" mark on the knob

aligns with the line on the knob support the

tension will be that indicated on the scale.

To increase tension by 1 or 2 lbs turn the